|
STAMP-ENGINEER is an integrated forming simulation system for virtual tool shop. This solution meets the various industrial needs from the engineers of automobile, electronics, iron and steel, etc. The STAMP-ENGINEER gives convenience to engineers, reliability to products, and robustness to tool shop via the advanced technology of the C3P Group.STAMP-ENGINEER was firstly programmed for automobile die-tool engineers by C3P Group in 2001.
|
 "PTC_AuthRes_RGB_LARGE-2")
 "actual case-173")
 "dc-173")
 "Case8a&b-173")
 "actual case2-173")
 "fender-173")
